Who doesn’t love Star Wars? If you’re a Star Wars fan, and of course you are, you’ll appreciate these easy origami Yoda instructions. This Yoda comes with a stand that also doubles as his robe. It’s a cute origami model that’s just as cute as the adorable and huggable, but ugly Yoda.
Easy Origami Yoda With Stand Instructions
Category: Origami Toys
Difficulty: Intermediate
Fold, you will! Create an Origami Yoda with our step-by-step guide—fun, easy, and a must-try for Star Wars fans and origami lovers!
Step 01
01
Start with a square piece of origami paper. I am using 7×7 inches origami paper for both head and body.
If you only have regular paper, follow these instructions on how to make a square origami paper.
If you only have regular paper, follow these instructions on how to make a square origami paper.
Step 02
02
Rotate the paper diagonally.
Step 03
03
Fold the left half over to the right by folding the left corner to the right corner.
Step 04
04
Unfold.
Step 05
05
Fold the bottom corner to the top corner.
Step 06
06
Grab both layers of the top corner and fold them down to the center of the bottom edge. The center is where the vertical crease is.
Step 07
07
Grab only the top layer and fold it up so that about half of the triangle will extend pass the top edge.
Step 08
08
Fold the tip down like this.
Step 09
09
Fold the left half straight up at the center.
Step 10
10
Do the same for the right half.
Step 11
11
Fold the top left edge to the center.
Step 12
12
Do the same for the top right edge.
Step 13
13
Fold Yoda’s ridiculously large ears down like this.
Step 14
14
Then fold his ears back up like this so that they point out to the side.
Step 15
15
Fold the chin up.
Step 16
16
Turn the paper over and draw his face. I’ll draw it in the end.
Step 17
17
Get out another piece of square origami paper and place the color side up.
Step 18
18
Fold the left half to the right.
Step 19
19
Unfold.
Step 20
20
Fold the top left and right edges to the center, but at a slight angle like in the pictures.
Step 21
21
Fold the bottom left edge to the center.
Step 22
22
Fold the bottom right edge to the center.
Step 23
23
Turn the model over.
Step 24
24
Fold the bottom corner to the top corner.
Step 25
25
Fold the top corner to the bottom edge.
Step 26
26
Turn the model over.
Step 27
27
Fold the left and right corners to the center.
Step 28
28
Turn the model over.
Step 29
29
Fold the top corner down like this.
Step 30
30
Slide Yoda’s head over the top of the body.
Step 31
31
Turn the model over.
Step 32
32
Draw Yoda’s face and voila!
Share and Comment
We would love to see your creations! Scroll down to the comments section and share a photo of your origami.
Leave a Reply