This origami stem is basically a generic flower stem that can be used for flowers such as the origami tulip. It consists of a stem with a leaf hanging out to one side. It is not difficult to fold at all and should take no longer than a couple of minutes.
How to Make an Origami Flower Stem
Category: Origami Flowers
Difficulty: Intermediate
Follow these origami stem instructions to learn how to make a nice base for your flower. Easy step-by-step instructions and helpful images.
Step 1
1
Start with a square piece of origami paper. I am using an 4×4 inches origami paper.
If you only have regular paper, follow these instructions on how to make a square origami paper.
If you only have regular paper, follow these instructions on how to make a square origami paper.
Step 2
2
Rotate the paper diagonally.
Step 3
3
Fold the left corner to the right corner.
Step 4
4
Unfold.
Step 5
5
Fold the upper right edge to the center.
Step 6
6
Fold the upper left edge to the center.
Step 7
7
Fold the lower right edge to the center.
Step 8
8
Fold the lower left edge to the center.
Step 9
9
Once again, fold the lower right edge to the center.
Step 10
10
Fold the lower left edge to the center.
Step 11
11
Flip the model over.
Step 12
12
Fold the bottom corner to the top corner.
Step 13
13
Fold the figure in half by folding the left side over to the right.
Step 14
14
Peel the leaf (on the left side) back.
Step 15
15
Reverse fold the peel. Voila!
Leave a Reply